cant get this dent out of my yak

So i Have this big Dent right in the middle of my prowler, My own dumb ass fault.........

I have had them before and popping them out was as simple as turning it upside down and letting the sun do its work.......This time that's not working at all.

I have tried using a huge wooden rod....broke that Ive tried The metal pry bar with boiling water, but keep warping around the opening of the hull. I def. dont wont to damage my Yak anymore then it is. Thought about a bottle jack but it too tall.

Im just plumb out of idea.....Got any? Ever had this happen to you?

Almost time for a new yak

- duct tape a large black trash bag over the dent and leave it under direct sun light

or....

- lay in on the lawn, put two foam blocks on each side of the dent and fill it up the kayak with water

It's supposed to go back by itself...eventually (no?)

Got a pic Chad? Theres Hobie vid that a dude made and he used real hot water to heat up the area. What made the dent and exactly where is it?

Got a pic Chad? Theres Hobie vid that a dude made and he used real hot water to heat up the area. What made the dent and exactly where is it?

Ill try to post pic. Saw the hobie video with compresses air and hot water......didnt work, my flush mounnts are not air proof . I left it right side up on the lumber rack in the 100 degree heat its right were i cant reach it. stand bye for pic.

- duct tape a large black trash bag over the dent and leave it under direct sun light

or....

- lay in on the lawn, put two foam blocks on each side of the dent and fill it up the kayak with water

Am i supposed to put the foam on the inside or the outside? Thanks for the tips mooch I miss u 

Is it on the deck or the hull?

Re-posting

If I get a stubborn dent in a rental boat I stick it up on a stand and pour boiling water onto the dent. This usually softens the plastic enough to push it back out. If not wedge something in the dent and use hot water. Sometimes kayaks just don't pop out.

pic

pic

Holy crap your not kidding! Hot water and a heat gun. Good luck man. Should pop out.

thanks guys Ill keep at it

I say fill it up with water and let it sit in the backyard.  The weight of the water and the warmth of the sun oughta slam it back in shape.  Good luck dad, you could always just get a hobie

I've seen Andy's yak worse than that!    Yet, somehow his dent's pop out too    Good luck, I say wait for a hotter day, like 85-90 and try the plastic bag like Mooch said 

I gotta know. How in hell did that happen anyway. Come on dude you can tell us. Like Dan said, I think you should put the boat right side up and support at either end and start pouring boiling hot water so it goes to the dented area. Try to apply side pressure on either side of the dent and hope for the best. If you cant get it done. I want a chance. Come over to Petaluma tomorrow and Ill fix it. I know I can.

Try the Hair Dryer high...