Truck Bed Slide ~$120..... SOLD!!!!!

It's become a point of contention so I'm selling it even though I don't want to.
Works like a charm. Sleep on top, store your stuff underneath w/o having to crawl into the truck or dig it out to get to it.
Special note: It's for a REAL truck.

Here's the original post after I made it.

http://www.norcalkayakanglers.com/index.php?topic=49616.msg551573#msg551573

The cost is what I have in materials. NCKA deal.
Otherwise CL for $200....very soon.

You made that? That's badass!
I wish I had a truck or is be all over that!

Do you have total length and width dimensions?

Do you have total length and width dimensions?

The length is 78.75" but the top board could be trimmed down making it 76''
The width on the bottom is 48.75", on the top (above the wheel wells) is 50.5" due to the rails holding the top board in place.
Total height is 14.5" inches.

Won't fit with out cutting everything down in size. 

Won't fit with out cutting everything down in size. 

You just need a REAL truck. 

On CL..$200

http://goldcountry.craigslist.org/pts/4644726768.html

Won't fit with out cutting everything down in size. 

You just need a REAL truck. 

It is too small for my truck. It will look like a toy in there.

I really was thinking about it till I saw the size. I am going to build one soon for my truck.

I really was thinking about it till I saw the size. I am going to build one soon for my truck.

I was looking at this in my garage just now and if you are handy with a skill saw this could easily be cut down to size.
Actually VERY easy. Especially since the design is already in place.

I really was thinking about it till I saw the size. I am going to build one soon for my truck.

I was looking at this in my garage just now and if you are handy with a skill saw this could easily be cut down to size.
Actually VERY easy. Especially since the design is already in place.

It's for my f350, not the Toy. It would be small in there.

Now thinking I may be able to add sides and a front section to make it work. I will think later when I can think. Sell it if you can.

Now thinking I may be able to add sides and a front section to make it work. I will think later when I can think. Sell it if you can.

You don't need to add anything. It's all already there.
Pretty much take off the top, rip it to the width you want.
Cut the top boards same width.
Cut the slide same width and the bottom the same width.
Take the 'scrap' wood off the side and reattach the side....done.
Same can be done with the length.
Cut from the back the length you want. Remove the 'scrap wood', reattach the back.
Actually pretty simple all in all.
I'd rather see it go to someone in NCKA.

It needs to be BIGGER, not smaller. I am contemplating adding BIGGER edges around the perimeter to not have stuff fall off of the top. Basically making your 4x6.5 a 5.5x8 foot box on top. I would make the edge areas ovr the wheel wells a hinged lid. My bed is quite a bit bigger than yours. I just need to decide if I want to have a slide in the bed at all.

Got it home, Tote. Looking forward to trimming off the back plate and building a new cradle for my yak. Enjoyed our meeting. Cheers.