What do you call this fitting?

I have been searching for one of these. What is it called?

I have been searching for one of these. What is it called?

I am not the expert, but it looks like a Hobie through hull fitting. I have used them on a previous kayak to route wires for a fish finder from inside the kayak hull through the top.

west marine should have them

Get this kit:  http://www.austinkayak.com/products/12509/Hobie-Thru-Hull-Wiring-Kit.html

Very clean looking and no silicone required

the exact part you're looking for is off a garmin transducer bracket. if you really want it you can order it from here:

http://www.amazon.com/Garmin-Replacement-Transducer-Bracket-010-10272-00/dp/B008ALQKLY



but i do agree with saw the Hobie thru Hull kit is a much better solution.

Thanks everyone.. I am trying to run my battery cable through the void in my yak. So, I need one more fitting. I like the hoddie fittings, I may go that way.
 Thanks again
  Steve

That little part is called a 'clamshell' or wire feedthru & can be found at a variety of places.  There is no need to order a whole install kit or transducer kit just to get that little part.

The best one I've found & used so far is the Hobie one.

No, it is called a "chingadero" 

No, it is called a "chingadero" 

Now you talkin my lingo " Homes "   

I have been searching for one of these. What is it called?

Arthur.

west marine should have them

I go to West Marine fairly regularly, I have never seen one there.  Try CCK.

These are available at most marine shops. You can buy them individually.

I've got them at West Marine in the past.

I call that a "thingamajigger".

Thanks everyone! Yakattack makes em too. They are a bit flatter than the Garmin style, but will work just fine. I saw them at Headwaters kayak in Lodi. Nice people there and just about whatever you could want for you Kayak.
 Thanks again
 Steve
 

By the way, its a dohiggie!