Need pointers.

Need some pointers. Hey fellas, is there a source you share fixing the up/down or pulley on hobie revo 13 rudder. TIA

What are the symptoms? Is it not going up? Not going down? Or nothing at all?

What are the symptoms? Is it not going up? Not going down? Or nothing at all?

Its not going up. I think the cable snaps. I will just replace it. Found a youtube video.

Same issue. Broken spectra line cable. Just replaced with Hobie spectra both up and down lines. I may be a bit retarded but it wasn't a snap job. Getting the lines around the pulley properly took several attempts. I pried out the little rubber sleeves in the plastic tubes and could run the line freely to tie into the Hobie existing line. Took a while to adjust but works fine now. This was on a 2012 Hobie and they made some changes on later models. Good luck.

Any slack in the line?  Could be the clip that holds the tension bungee to the line is undone. 

I replaced several times repairing/replacing lines on my old Oasis using the attached manuals.
If you want to save time, you might want to buy Hobie Mirage Rudder Up/Down Line Kit Universal. 
https://www.austinkayak.com/Hobie-Mirage-Rudder-UpDown-Line-Kit-Universal/ACK3325P.html

Replacing a line takes 30-45 minutes.

Paul

Any slack in the line?  Could be the clip that holds the tension bungee to the line is undone.

Yup loose like a mother goose