Anyone know the Dia of eagle 350 s/map transducer???

Was wanting to prep the yak with noodle and I have noodles where the inside hole looks to be 1"...any input would be grateful... have on order eagle 350 s/map...

thx...

?

?

I'll put some gorilla glue on that "?" it might fit...

OH I get your ? now!    It's not something that you want to pre-cut if your waiting for the FF to arrive.  Wait till it does, cut a 1.5-2 inch puck and place the transducer on it.  Trace around it with a sharpie and then cut the inner diameter out with a fillet knife or a razor.  Do it slightly smaller than the size of the transducer, you want it to fit in snug!  That way it will not spill water when you press it in place.

Oh and also sand the area your going to mount it, so the glue has something to adhere too. 

OH I get your ? now!    It's not something that you want to pre-cut if your waiting for the FF to arrive. 

Thanks...yep sitting waiting...been reading and reading and realized I have to wait...

It's showing up tomorrow along with a grip of lures and new line

Stripers @ Mendo Sat Baby!!! Since the ocean's blown out...

Once again thanks for all the imput...