Nice catch. We're you trolling and what bait.

thanks for all the feedback guys.  I think I will just put a ring next to the sailing mast area and tie it there and then use the bungee to hold it in place.  take care everyone.

sakana, thanks for the suggestion

Hi

I was wondering what was best method to tie down your 180 drive for beach launch/ landing.  I was about to put a ring on the front wall of the yak ( next to the sail post) and leash it there but decided to check to see what other revo owners were doing first, and if there was a preferred method.   thanks in advance.

I recently got my Revo 13 and after I scratched the keel I tried the PVC pipe method and found that it was quite difficult to work with since it was so thick. 

while the PCV solution worked,  it came off when the keel it the floor at a  certain angle.  I believe this happened because the PVC was too hard and had no give when the keel hit the ground.  The other possible reason was that the industrial strength  3M tape was still not strong enough to hold it in place.

I tried using a clear pipe and that was easier to work with and it is softer and has a bouncy feel and so far it has held on even after I dragged it across the tarmac last week.  Need to do a some surf landings to confirm if it really works.

If I had to do it all over I would probably try JB weld first as some members here have done.

Hi

I am trying to install a GT90 track behind the seat on the left side.  There is black float inside the yak and I am not sure how to remove it so that I can screw in the GT90 track nuts.  IS there a way tpo install the GT90 track without removing the black float?

Also is there a document that shows all the internal parts ( strings, pulleys,etc ) of the revo 13?  I found alot of diagrams for the outback on the hobie site but nothing on revo 13.  I must not be searching correctly.

thanks in advance

thanks for sharing!

Hi EVeryone.

I just got my Revo 13 and i noticed that there is a single black float inside the kayak. and it was only on the right side.  was there suppose to have been 2 floats?

Can anyone with a revo 13 confirm how many internal floats there are supposed to be?  Mine is the 2020 model.

thanks