Quote from: Sattes on March 12, 2017, 10:10:48 PM

If you want to save some coin.  Look into the Everlast welder company.  They are local and their products are good.  I have a 250 amp multi process tig setup from them and it has been flawless for 3 years.

This thing looks kinda sick
http://www.everlastgenerators.com/product/multi-process-tig-stick-plasma/powerultra-206pi
What u guys think

Put some blood on that thing.  Catch some fish.

Quote from: Sattes on February 27, 2017, 03:33:49 PM

Thank you all for the great advice.  I have looked up all methods.  And all input is much apreciated.  I wonder if a heat gun would help all the bubbles escape from the goop.  Kinda like epoxy when rod building.  Well when I finally do my install I'll be sure to bore you with a step by step with pictures.  Thanks again.

I just put the goop in my pocket for a couple minutes, so that it's easier to squeeze out. I think a heat gun (or even a hair dryer) might be too much and actually cause bubbles.

I suspect that when people have trouble with air bubbles, it's because the goop has pulled away from the hull, or the transducer moved while the goop was drying. To prevent the former, scuff the area lightly with sandpaper and clean with rubbing alcohol. For the latter, use some sort of cutout (i.e., pool noodle) to keep the goop from running out, and put some weight on top of the transducer for 24 hours.

Solid lineup.  I just got back into bass fishing last summer.  I picked up a handful of curados (200's and an x70) and a 13 Concept C. 

After a couple trips the 13 was so buttery smooth that I unintentionally grabbed it first whenever I pulled up on a spot.  Perfect for crank and jerk baits, casts well and light enough to throw all day without fatigue. 

Two issues I had, the exterior finish chipped and the beetlewing side plates use a sliding release to open them......and the release opened a couple times while bouncing around in a rocket launcher style holder.  Not sure if that'll be an issue on the yak but I'm not a fan of the design.  Most reels have the same style release but the 13 was the only one I had issues with.

And I couldn't resist the a3 either lol, added it to the quiver last month.



Sent from my SM-G928T using Tapatalk