1
Craftsmen's Corner / Re: Hullivator shock replacement / upgrade
« on: August 19, 2021, 04:43:13 PM »
https://www.grainger.com/product/BANSBACH-EASYLIFT-Gas-Spring-6EYH8
Here’s for starter. You can go stainless but it’s 115$ each.
Drilled the huge rivets out and hacked/put together threaded rod as rivet replacement. Nuts used on each side to hold the rod / strut together are like t bolt type. I think it’s 1/4x20 size.
It works but I wish I used the 120lbs coz I only used the 100.
Carries the Outback not bad.
PS if you gonna go diy route. The gas springs needs to be compressed and it’s basically a Hail Mary that the straps you use(I used racheting strap and hacked wire hanger to compress) hold up.. if not it might explode on your hand or something or maybe not.
Here’s for starter. You can go stainless but it’s 115$ each.
Drilled the huge rivets out and hacked/put together threaded rod as rivet replacement. Nuts used on each side to hold the rod / strut together are like t bolt type. I think it’s 1/4x20 size.
It works but I wish I used the 120lbs coz I only used the 100.
Carries the Outback not bad.
PS if you gonna go diy route. The gas springs needs to be compressed and it’s basically a Hail Mary that the straps you use(I used racheting strap and hacked wire hanger to compress) hold up.. if not it might explode on your hand or something or maybe not.