NorCal Kayak Anglers

Kayak Fishing Zone => General Fishing Tips => Topic started by: Chet on September 21, 2017, 01:23:28 PM

Title: [How to] fix broken rod
Post by: Chet on September 21, 2017, 01:23:28 PM
Here is how I fixed it.


https://youtu.be/AO7l7oFo0OM
Title: Re: [How to] fix broken rod
Post by: Spring45 on September 21, 2017, 03:35:12 PM
Thanks for sharing that!!
Title: Re: [How to] fix broken rod
Post by: KPD on September 21, 2017, 06:29:50 PM
Nicely done, Chet.
Title: Re: [How to] fix broken rod
Post by: Fisherman X on September 21, 2017, 06:58:00 PM
Nicely done, Chet.

Agreed. Keep us informed as to how it performs and holds up.
Title: Re: [How to] fix broken rod
Post by: Scurvy on September 21, 2017, 08:52:00 PM
I imagine the internal epoxy should be adequate since the splint transfers the loads across the joint and back into the rod tube.  If going without the external wrap, then it's probably better for the splint to fit somewhat loosely inside so that the epoxy is fully bonding it into place on all surfaces.

I hate to say it, but this is where buying the high-end rods pays off since most of the manufacturers/builders will provide replacement sections for these very problems.
Title: Re: [How to] fix broken rod
Post by: Wildrooster on September 23, 2017, 02:06:16 AM
Good job
If you need to do it again try a Mylar wrap it will make it smoother except for the seam line we're the Mylar wrap started.
 you can easily sand down that edge which will be the thickness of the Mylar
the Mylar should extend well past the repair area and can be held in place with simple shipping tape
If you don't have Mylar you can use wax paper but depending on the quality you may want to use mold release to insure easy removal
When Mylar is use you don't need mold release it will naturally come off  as long as it's not held it place by excess fibers or resin
Title: Re: [How to] fix broken rod
Post by: Ski Pro 3 -- Jerry on September 24, 2017, 03:03:12 AM
That's a really clean repair.  I'm not so meticulous with my fixes.

I use a BIC ball point pen.  Pull the inside out, leaving a clear plastic tube.  Cut to length, fill with epoxy and slide the two parts of the pole into the tube and let it set.  I keep a supply of individual use 2 part epoxy in my tackle and there's always a pen in the truck.