1
Hobie Kayaks / Re: Guide - Metal 180 MD Sprocket Installation
« on: March 24, 2024, 05:26:12 PM »
Great job summarizing this! Looks sharp.
by LoletaEric
[March 28, 2024, 11:47:21 PM]
[March 28, 2024, 11:34:08 PM]
by SpeedyStein
[March 28, 2024, 09:44:18 PM]
by BsHawk
[March 28, 2024, 09:12:36 PM]
by scottymeboy
[March 28, 2024, 07:11:09 PM]
by polepole
[March 28, 2024, 01:13:46 PM]
by polepole
[March 27, 2024, 07:25:42 PM]
[March 27, 2024, 07:05:39 PM]
by bbt95762
[March 27, 2024, 12:35:34 PM]
by SpeedyStein
[March 27, 2024, 11:18:23 AM]
by Sailfish
[March 26, 2024, 07:45:07 PM]
by SpeedyStein
[March 26, 2024, 06:19:03 PM]
[March 26, 2024, 05:47:06 PM]
Support the site by making a donation. |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to. 1
Hobie Kayaks / Re: Guide - Metal 180 MD Sprocket Installation« on: March 24, 2024, 05:26:12 PM »
Great job summarizing this! Looks sharp.
2
Craftsmen's Corner / Re: Mirage Drive 180 Replace and Repair Bearing Races?« on: March 22, 2024, 07:51:53 AM »
So the Hobie recommended fix for a broken sprocket is to replace the entire spine. So, I ordered a new spine (MD 180 with Kick up fins) and the vendor sent a spine fully equipped with the idler roller and two new drums. So, last night I put all of the remaining parts on the new spine and interestingly, the original chain cables were not long enough. I swapped out the chains from another drive and same thing. Then I got to measuring - why would they not fit? Turns out, this new spine has about 1/4" more length from the base of the sprocket to the ridge the sprocket housing is attached to than on both of my older drives (one with KU fins, one MD 180 w/o).
Has anyone experienced this before? I havent had the chance yet to look if Hobie makes longer chains, or if you can add a chain link or two to add room. Also, I wonder if the knock-off chains on amazon are a bit longer? I just need another half inch to an inch of length to make up for the longer trip around the sprocket. Seems messed up. I ordered the spine from Sunjammers in Florida. Got here quick and the quality seemed perfect. 3
Craftsmen's Corner / Re: Hobie Mirage Drive 180 reversing lines in the spine video« on: March 20, 2024, 12:54:59 PM »
I literally scoured the internet last night looking for this video - I dont know it exists, but I feel it does... like bigfoot.
I have a new 180 w/ KU spine on the way, my 180 w/ KU spine with a single broken sprocket (nothing else wrong), and an old spare 180 drive that needs to be retired. I am (kind of) contemplating replacing the broken spine with a single working sprocket off of the old 180 drive, so I have two (like new) mirage drives. This involves me cutting, or removing the lines to one side, removing the broken sprocket, then re-running the lines on one side through the replacement sprocket. May be more trouble than it is worth. 5
CA Regulations / Re: CDFW Inseason Groundfish Recommendation« on: March 08, 2024, 11:25:02 AM »Why the November <20 ftms? What is so special about sharktober that they want to limit inshore fishing? This doesnt seem to make much sense. Good point, and those things are true, but there isnt really an ecological or biological reason to close october, open Nov, and close December to inshore fishing, so why regulate it unless it is for these less-important reasons? 6
CA Regulations / Re: CDFW Inseason Groundfish Recommendation« on: March 08, 2024, 10:52:57 AM »
Why the November <20 ftms? What is so special about sharktober that they want to limit inshore fishing? This doesnt seem to make much sense.
7
For Sale / Re: Columbia Hoooded Tee at Costco $16.99« on: March 06, 2024, 09:04:37 PM »Lots of em. I can relate to that. I got a wahoo in MX and it bled all over my Columbia hoodie, and now, I won't wear another. Bloodstains are important! 8
Fishing Tournaments and Events / Re: Gimme Shelter XVIII - It might be a thing...« on: March 02, 2024, 09:40:16 PM »9
General Talk / Re: surf launch/landing« on: February 06, 2024, 12:24:15 PM »
Wasn't totally clear from the video, but how did they crack the kayak on both scuppers and snap their paddle? Maybe it was the air time going over the crest... not too sure. Cowabunga!
10
General Talk / Re: Which paddle for a 6’2” dude in a old town Predator PDL« on: February 02, 2024, 07:25:06 AM »
I paddled an OTP for a while and found that the shorter sized paddle would hit the gunwales on my stroke sometimes, so I upgraded to the 260 cm and that worked much better. I am 6'2" as well. Hope that helps.
11
General Fishing Tips / Re: you all fishing the ocean. do you see fishing jet-skies out there?« on: January 27, 2024, 08:54:59 AM »
We ran into a guy mooching for salmon at the cove one time on a jetski. It looked like a pretty cool setup and very agile on the crowded fishing grounds that particular day. Still happy to be talking tho.
12
General Talk / Re: Fish results spreadsheet for 2023 vs 2022« on: January 03, 2024, 09:51:28 AM »I might need to focus more on work, since it definitely took a hit last year. Just bought a midweek season pass so I will have to allot more days to skiing. . Priorities people!!! I hope you get 60 days fishing Joe, and happy ny to you and Mabel! 13
CA Regulations / Re: Beaver Observation Survey« on: January 02, 2024, 06:31:15 PM »Happy to be of service!I came here to learn about beaver observation. 14
CA Regulations / Re: Beaver Observation Survey« on: December 28, 2023, 08:43:48 PM »
I came here to learn about beaver observation.
15
General Fishing Tips / Re: Advice for keeping dungeness fresh« on: November 27, 2023, 12:42:26 PM »
Thanks for the crab tongs link! I had the same question regarding temperature. The cool late november days and evenings made storing this tank in the garage pretty much perfect. I doubt the water fluctuated much between 50 and 60. |